Glue Board

Lay out on 3/4 inch ply wood.

I’m  adding the neck to make sure i get the alinement nice and strait.

The side is used to trace out a second line.

Dividers are used to mark off 7/8th increments around the perimeter.

4 inch holes are cut and small holes are drilled.

L hooks are screwed in.

The L hooks now keep the sides in a place ensuring symmetry.

Top in place.

Just a few rubber bans hold it nicely in place.

This is a good time to do a little flattening.The light  show’s what needs to be done.

Sand paper on the board until you are dead flat.

More rubberbands.

Access holes let me see whats going on inside.